AMERICAN furnishes a line of 54"-64" Lok-Ring fittings that meet the applicable requirements of AWWA C110 or C153, depending on diameter and configuration. These fittings employ the standard Fastite seal, and the joints meet the applicable requirements of AWWA C111. Many of these fittings are not specifically listed in the AWWA standards because of joints, outlets or other variations, and as such are designated as “AMERICAN Standard.”
Lok-Ring fittings are furnished of only ductile iron. They are furnished complete with standard Fastite plain rubber gaskets and a sufficient supply of Fastite joint lubricant.
Lok-Ring fittings are normally furnished with standard cement lining in accordance with AWWA C104 and with a standard asphaltic coating on the outside. For special conditions, other types of coatings and linings may be available.
Size | A | C |
|---|---|---|
54 | 57.56 | 12 |
60 | 61.61 | 13 |
64 | 65.67 | 13 |
1.) The laying length of fitting plain ends is not necessarily the same as the gauge length. In general, depending on the fitting configuration (C110 or C153, etc.) and also the size and joint, the laying length of a fitting plain end will be approximately 8"-10" longer than the laying length of the same fitting with a bell end. Contact AMERICAN when more precise dimensions are required.
